Currier Tech Scoot-E DD Series Owner's Manual download pdf (Page 39)

Use only Currie Authorized Li-Ion chargers with bicycles equipped with Li-Ion batteries.

Using any other charger will damage the batteries and void your warranty.

Use only Currie Authorized NiMH chargers with bicycles equipped with NiMH batteries.

Using any other charger will damage the batteries and void your warranty.

How to use the NiMH and Li-Ion Chargers

Before using the charger locate the voltage selector switch (NiMH

and Li-Ion chargers only) on the back of the charger. Select either 115

Volts or 230 Volts depending on the country you reside in. Using the

wrong voltage setting will permanently damage the charger and/or electrical

components on the hybrid electric bicycle.

Plug the charger into the outlet and turn the charger “ON” via the switch on 1.

the back side. The red power light on the front of the charger will illuminate

when the charger is working properly.

Insert the XLR plug (round plug with 3 pins) into the charger port on the 2.

bike being sure the charger plug is fully seated in the charger port. The

second light will start to ﬂ ash orange for several seconds while the charger is

“seeking” the battery.

Once the charger has "found" the battery the blinking orange light will stop 3.

ﬂ ashing and turn solid orange and the cooling fan will start. At this point the

charge process has begun.

Once the battery reaches full charge, the orange light will turn solid green.4.

When charging is complete, unplug the charger from the wall before removing 5.

it from the charger port.

Charge for the full time. If the battery still has not charged, you may need to replace it.

FUSE

115

Back Side of Charger

Front Side of Charger

Orange/Green light

Voltage selector switch

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 139 140

No comments

Currier Tech Scoot-E DD Series Owner's Manual Page 39