TWIST AND GO! To start scooter turn the power switch “ON”. Twist throttle and go.ATTENTION!OWNER’S MANUAL(CHAIN DRIVE SCOOTER SERIES)You must read and
10Customer Service 1-800-377-4532Currie Technologies®Insert the stem into the steerer tube. Be sure to insert stem past the “Minimum Insertion Mark”.1
11www.CurrieTech.comCurrie Technologies®Open the stem hinge to access the steerer bolt (6mm Allen Bolt or 13mm Hex Bolt). 3. Loosely tighten the steer
12Customer Service 1-800-377-4532Currie Technologies®Rotate the stem QR lever forward into of the upper plate (Ref Photo A). Close the stem QR lever (
13www.CurrieTech.comCurrie Technologies®Align the handlebars to the front wheel. The handlebars must be perpendicular to the front wheel.8. Repeat ste
14Customer Service 1-800-377-4532Currie Technologies®QR LEVER ADJUSTMENT:If the quick release lever is either too tight (cannot be flipped to its full
15www.CurrieTech.comCurrie Technologies®BATTERY PACK, CHARGER PORT AND CHARGERELECTRO-DRIVE™ SMART CHARGER: The Electro-Drive™ scooter comes with its
16Customer Service 1-800-377-4532Currie Technologies®using the Currie “Smart Charger”, we recommend that you do not leave the charger plugged in for m
17www.CurrieTech.comCurrie Technologies®BATTERY CARE AND MAINTENANCENot doing any and/or all of the following may lead to reduced performance and/or p
18Customer Service 1-800-377-4532Currie Technologies®THROTTLE AND BRAKE OPERATION & ADJUSTMENTTHROTTLE OPERATIONThe speed of the Electro-Drive™ sc
19www.CurrieTech.comCurrie Technologies®The line voltage will fluctuate depending on the instantaneous load that the motor is under. For example, when
2Customer Service 1-800-377-4532Currie Technologies®PLEASE DO NOT RETURNTHIS ITEM TO THE STORE. For questions or assistance on assembly contactCurrie
20Customer Service 1-800-377-4532Currie Technologies®BRAKE OPERATIONThe Electro-Drive™ electric scooter is equipped with front and/or rear brakes. It
21www.CurrieTech.comCurrie Technologies®WARNING!DRIVE TRAIN ASSEMBLYThe Electro-Drive™ electric scooter is equipped with the patented Currie Technolog
22Customer Service 1-800-377-4532Currie Technologies®CHAIN ADJUSTMENTThe chain can stretch during use or may occasionally come out of adjust-ment. Reg
23www.CurrieTech.comCurrie Technologies®watching the chain. Be sure that the rear wheel is turning smoothly and the chain does not try to run off the
24Customer Service 1-800-377-4532Currie Technologies®WHEEL REMOVALFRONT WHEEL REMOVAL300, 4.0, 400, 500CD, 650CD, 750CD AND 900CD SERIES SCOOTERSDetac
25www.CurrieTech.comCurrie Technologies®Photo BPhoto APhoto CPhoto DREAR WHEEL & DRIVE ASSEMBLY REMOVAL300, 4.0 AND 400SERIES SCOOTERSTurn the pow
26Customer Service 1-800-377-4532Currie Technologies®Photo EPhoto FLoosen and remove both 15mm axle nuts. (Ref Photo E)Loosen and remove both 10mm cha
27www.CurrieTech.comCurrie Technologies®Set the motor into the empty battery tray. Loosen and remove both axle nuts with a 15mm wrench (Ref Photo B).L
28Customer Service 1-800-377-4532Currie Technologies®WHEEL INSTALLATIONFRONT WHEEL INSTALLATION:300, 4.0, 400, 500CD, 650CD, 750CD AND 900CD SERIES SC
29www.CurrieTech.comCurrie Technologies®REAR WHEEL INSTALLATION300, 4.0 AND 400 SERIES SCOOTERSThe order of this installation is very important. Start
3www.CurrieTech.comCurrie Technologies®TABLE OF CONTENTSSection 1 . . . . . . Technical Information . . . . . . . . . . . . . . . . page 3Section 2 .
30Customer Service 1-800-377-4532Currie Technologies®Proper braking performance is critical for safe riding. Currie Technologies® strongly recommends
31www.CurrieTech.comCurrie Technologies®FLAT TIRE REPAIRFRONT WHEEL4.0 AND 400 SERIES SCOOTERSTo remove the front wheel refer to page 24 then proceed
32Customer Service 1-800-377-4532Currie Technologies®(if your scooter is equipped).Slide the axle through one half of the rim, and place the center (l
33www.CurrieTech.comCurrie Technologies®To reassemble the front wheel, first slightly inflate the tube to allow it to take shape then install into the
34Customer Service 1-800-377-4532Currie Technologies®Section 5 - FAQ’SHOW FAR WITH THE ELECTRO-DRIVE™ SCOOTER GO ON A FULL CHARGE?Maximum range per ch
35www.CurrieTech.comCurrie Technologies®HOW OFTEN SHOULD I RECHARGE THE BATTERIES?Recharge your batteries immediately after every ride. Your scooter w
36Customer Service 1-800-377-4532Currie Technologies®Section 6 - LIMITED WARRANTYCurrie Technologies® manufactured or distributed “Electro-Drive™” pow
37www.CurrieTech.comCurrie Technologies®The Currie Technologies® Limited Warranty does not cover or apply to any Currie product used for rental or com
38Customer Service 1-800-377-4532Currie Technologies®Section 7 - PRE-RIDE CHECKLISTIt is recommended that you perform each of these checks before each
39www.CurrieTech.comCurrie Technologies®NOTES:________________________________________________________________________________________________________
4Customer Service 1-800-377-4532Currie Technologies®Section 2 - SAFETY GUIDELINESLIMITATIONS OF SAFETY AND WARNING NOTICESThis owner’s manual includes
Specifications subject to change without noticeElectro-Drive™ electric scooter are manufactured and distributedexclusively by Currie Technologies® Mad
5www.CurrieTech.comCurrie Technologies®Never operate this product without proper training or instructions.Children under 13 years old should never ope
6Customer Service 1-800-377-4532Currie Technologies®Never operate on excessively rough, slippery or loose terrain.Practice turning at low speeds befor
7www.CurrieTech.comCurrie Technologies®STARTINGTurn the power switch to the “ON” positionPlace one foot on the deck with both hands on the handlebars.
8Customer Service 1-800-377-4532Currie Technologies®Section 3 - BASIC ASSEMBLY & SET-UPIMPORTANT: Some adult assembly required. Before using your
9www.CurrieTech.comCurrie Technologies®to the scooter first then plug the charger into the wall socket. Allow the batteries to charge a full 6-10 hour
Comments to this Manuals